Basically, this was an idea my gf came up with yesterday when my daughter was givin a little electronic dog. The idea was to tear it apart and make it rc so she can drive it around.. So after some thinking, I went to work, since I had some stock electronics from a hotwheels rc car.. So heres some pics of where the "dog" is at.. its basically done, besides im trying to work some of the stock servo stuff into the rc electronics, hopefully i can get it to work right, s ince it wasnt really a servo, just a part of one, than itll save me time from finding center of where it turns and mounting a servo myself.

HAHAAHHAHAHAHAHAH

hopperguy, you are ahmazing!

i found it funny too, even when i work on it.. im trying to use as much as the stock as i ican, i got the driving setup already, and been tested.. it runs at a perfect speed for her to control it and chase her little cousin with it, since hes scared of dogs, lol

so when are you going to make it into a brushless drag racing dog?

never, i doubt this mutt could handle the extra power, lol.. plus its for a young 2 yr old.